兄弟打印机从粉盒齿轮清零

The cleaning process for the Brother printer from the fender gear is essential for smooth operation and to avoid any issues.

First, unplug the printer from the electrical outlet and turn off the power switch.

Next, remove the toner cartridge and drum unit from the printer. Carefully set aside the cartridge and unit on a flat surface.

Once the drum unit and toner cartridge has been removed, locate the fender gear near the back of the printer. This item will be clearly visible if you look in the area where the cartridge was located.

The fender gear should be rotated counter-clockwise until it has been reset to the “0” mark. To do this, use a small flathead screwdriver to rotate the gear one full rotation counter-clockwise. You may need to rotate it a few times to get it back to the original “0” mark.

Once the gear has been rotated to the “0” mark, re-install the toner cartridge and drum unit. Reconnect the printer to the electrical outlet and turn on the power switch.

Finally, perform a few test prints to ensure the printer is operating correctly.

If all is well, you have successfully cleaned the fender gear from your Brother printer.

未经允许不得转载：远程打印机维修网 » 兄弟打印机从粉盒齿轮清零